11 Steps to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair

11 Measures to Spray Paint Your Car Like the Professionals - Car Bodywork Paint Repair



You may be surprised to see only the way to spray on car paint actually can not be difficult. That does not mean that you go at it and can just grab a tin of paint. There are some fundamentals you must know. Both in the preparation and application.

Step A:

Prepare by assembling all of your things that you're going to need. Be sure your surrounding area is protected against any potential finished aerosol. For other regions cover well with paper and masking tape.

Measure B:

You may have to analyze the car for any rough spots. These will need to be sanded with 300 grit sand paper. Additionally, it allows the aerosol auto paint to stick better. Ensure all the dust dirt and debris are taken from the vehicle, once you have finished sanding. It's imperative that the auto be absolutely clean.

Measure C:

You'll need to apply a primer. This will make sure that you get an overall even coat of your colored paint plus helps the paint to adhere nicely. Be sure to apply light coats and allow for drying in between when you spray the primer. The best way to spray on car paint takes a little getting used to.

Step D:

Now you're pretty well to the point where you are around ready to spray on the colour. You may have determined to use the spray car paint that comes in aerosol cans, or perhaps you might have chosen for the spray gun. Before you start with the automobile in any case, make a couple of practice Alloy Wheel Repair Billericay strokes on an item. After you are ready, start the passes with the paint without reluctance. If you hold the spray can or gun in one place, you may end up with coverage that is uneven and potentially the paint will run. If it happens you've got a major repair job on your had. You'll most likely have directions regarding how you can spray on car paint using the spray or gear cans.

Step E:

Check with someone which is familiar with just how to spray auto paint, or you might want to study this choice on the internet

Step F:

You are down to the finishing touches once you happen to be thoroughly satisfied with the color. You'll now want to apply several coatings that are clear. This can give the finished and polish look to the automobile together with protect the finish. Likely two coats will be sufficient but it's going to be up to you personally. Make absolutely sure it's dry in between coats.

Step G:

Yet again, you have the alternative of wet sanding if you favor. Again, it is suggested you ask the advice of people which can be comfortable with the way to paint a car. If you determine to follow this step then you need with the following grits in this sequence. This will remove spots that may be too heavy in the clear coating application.

Step H:

Step I:

You should buff the surface. To do this simply use a moderate cut polish.

Step J:

As a final touch, you might want to apply a number of layers of wax.